To enable debug messages and start recording a log file with u-center follow the steps below.
- Please increase the baud rate to 460800 or higher value (if using UART as serial communication interface with F9P). Refer to Note 2 at the end of this article for details.
- At the top navigation bar click on the "Enable all debug messages" button.
- Next, click on the "Record" button.
- Choose the location of the log file and create a descriptive .ubx log file name.
- Select the generation of your receiver (e.g. u-blox Generation 9 is for F9P) and click yes.
U-Center will transfer configuration and log information to a .ubx file.
- Once you are done recording just simply press the Eject button.
More information about u-center is Here
Note:
1. If you need support to troubleshoot an issue, u-blox would need a 15-30 minute log. Please share both the logs (.ubx) and configuration file (.txt) generated for best results in your support ticket. If the configuration file cannot be found, generate one manually using Tools, Receiver Configuration.
2. The F9P has a default baud rate of 38400. When debug messages are enabled, the amount of data transmitted increases, which may lead to the buffer space being exceeded. When this happens, new messages won't be sent. To prevent this message loss, it is recommended to increase the baud rate to the maximum that your hardware can handle. If the baud rate cannot be set higher, then it is important to carefully select the number of enabled messages to ensure that the expected number of bytes can be transmitted in less than one second.